Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in Cumming, GA
A photo of a finished garage door tells you more in three seconds than a page of adjectives ever could. In Cumming, where our humidity, pollen load, and afternoon thunderstorms age hardware faster than homeowners expect, we document every job with a full photo record per The Haven Standard. These are representative transformations from the kind of work we’ve handled across Cumming since 2015, roughly 18,000 doors so far. Each one got a written price before we touched a bolt.
Recent Transformations
Torsion Spring Failure on a Clopay Steel Door in Vickery
The left-side torsion spring snapped clean at the coil on a Clopay double-wide door that had been in service since 2012. That single failure put the full weight of the door on the opener, which is how motors burn out in a week. We replaced both springs as a matched pair, verified the new wire diameter and coil count against the door’s actual weight, and ran a balance test at three heights. The homeowner received photos of the broken spring before we quoted, then a written price, then a set of after photos showing the new springs in place and the door moving under its own weight again. Total time on site: just under two hours.
Full Door Replacement for a Weather-Worn 16×7 in Cumming
A builder-grade steel door from 2006 had rotted through the bottom panel, where Cumming’s red clay soil and standing water after spring storms had eaten the metal from underneath. The track was bent out of square, which meant the door also sat crooked in the opening and let in everything with wings. We measured the opening, wrote a flat price for a full replacement including new track, new springs, new seals, and haul-away of the old door, and scheduled the install for a weekday morning. The customer signed off on the written scope before the first panel came off the truck. After photos show the new Amarr insulated door, a painted trim match, and a clean garage floor.
Opener Motor and Logic Board Failure in Cumming
The LiftMaster opener stopped responding to both remotes and the wall button. We tested the outlet first, then the safety sensors, then traced the problem to a fried logic board, which the owner confirmed with a photo of the board before we quoted the replacement. We carried the board on the truck, installed it, reprogrammed the remotes and keypad, and ran the door through fifteen complete cycles while checking the force settings and travel limits. The homeowner walked away with a photo record of the failed board, the new board installed, and a written warranty on the part. Same-day fix, done before noon.
Cable and Drum Mismatch on a Wayne Dalton Door
We pulled into a driveway in south Cumming where the right-side cable had come off the drum and wrapped itself backward around the shaft. What made it interesting, and not in a good way, was that the drum wasn’t even correct for a Wayne Dalton door. Somebody had swapped in a mismatched drum at some point, and the cable had been fighting it since day one. We replaced both drums and both cables with the correct sizes, reset the cable tension, and photographed the before condition while the door sat cockeyed in the tracks. Springs and cables are under high tension, genuinely dangerous to work on without training and the right bars, which is exactly why we documented everything we touched. The door now runs level top to bottom and stays quiet through the full travel.
Safety Sensor Failure on a Genie System in Cumming
The door would start closing and then reverse about eight inches from the ground, which is the classic symptom of a failing photo-eye sensor. The left sensor’s LED was flickering instead of burning steady, and the bracket had been nudged askew by a trash can. We replaced the sensor pair with a new set, squared and leveled both brackets, and cleaned the lenses. The fix took forty minutes and the door closes on the first press now. This is the kind of repair that looks tiny until it’s not, a door that won’t close is a door that can’t secure the house.
Insulated Door Upgrade for an Attached Garage in Cumming
An attached garage on the north side of Cumming had a non-insulated steel door that sweat through the summer, and the moisture was rusting the bottom edge and staining the concrete. The room above the garage never held temperature. We replaced it with a Clopay insulated door with an R-value that actually matters for a space you walk through every day. New perimeter weatherstrip, new bottom seal, new hinges and rollers, all written into the flat price up front. The result is a door that seals tighter, runs quieter than the old one ever did, and gives the garage a fighting chance in July.
Want Results Like These?
Every job we do in Cumming starts with a written price and a written scope before any work begins, then ends with a photo record of what we found and what we did. If you’ve got a door that isn’t right, call (470) 758-8863. We answer live, every hour of every day. Free estimates, written everything, and if you bring a competing written estimate, we’ll give you a free second opinion on it.
Written by Marcus Deller, Owner at Servo Garage Doors Cumming, serving Cumming since 2015.